Warning: Please do not plug or unplug the POE RJ45 cable from the ORS while injector is powered on.

To unplug ORS: Unplug the electrical cord between the POE injector and the electrical outlet, wait 30 seconds, then unplug the RJ45 POE
To plug ORS: plug RJ45 POE to the ORS, then plug POE injector to electrical outlet

Doing otherwise might break some electrical components inside the ORS. Even if the ORS has been manually powered off through SSH (for those having root access) you still need to follow this procedure to unplug it.

Take out all the accessories

You will need your ORS, two N to SMA adaptors, two antennas, the POE cable, the POE adaptor, and the POE power supply cable.

For ORS Duo, you will additionnaly need two more N-SMA adaptors and antennas, as well as two N-N male to female adaptors so that the antennas don't overlap.

Plug RJ45 POE connector without powering on

Plug a non-powered waterproof RJ45 POE connector (or a normal RJ45 cable). For the waterproof connector, make sure to turn the connector clockwise all the way to the end after plugging it.

Screw the N to SMA adaptors

Make sure the adaptors are screwed all the way to the end, you don't have to screw it very tightly.

Screw the antennas

For ORS:

For ORS DUO:

Make sure the antennas are tight, then carefully screw them all the way to the end by holding the part closer to the ORS. Be careful as the antennas are a little fragile

Turn the antennas facing up

Hold the end of the antennas and slowly and carefully turn them to make them face up.

Space the antennas apart from each other

Space the antennas apart from each other for a better radio transmission and emission.

Plug POE and network to POE adaptor

Plug the POE cable to the POE port of your POE adaptor, and the network cable to the LAN port of your POE adaptor. Make sure your POE adaptor is not yet powered on, the blue LED should be off.

Cable requirements

If you need to use different cables (for instance if you need a longer POE cable) please make sure the following requirements are met:

The PoE cable must be at least Category 6, it is particularly important for it to be shielded
The PoE cable length must not exceed 50 meters

Power injector requirements

If you need to use a different power injector, please make sure the following requirements are met:

The PoE injector must provide at least 50W
The PoE injector must have a voltage range between 24V and 57V
The PoE injector shouldn't implement the negotiation protocol of the spec IEEE 802.3bt (PoE++) but it should deliver directly the full power (passive power injector)

Take out all the accessories

Remove N Caps